| Quick facts | Answer |
|---|---|
| Cost range | $2,000-$6,000 typical; $500-$1,200 for a 6-10 fixture low-voltage system |
| Time | 3-5 hours for wiring and one light; 4-8 hours for 10 fixtures |
| Who's qualified | A licensed electrician must connect the power source; landscapers may install low-voltage fixtures only |
Pflugerville, TX: what's different here
Pflugerville sits just northeast of Austin, about 17 miles and roughly 20 minutes away by car via I-35 N. That short drive means Austin-area electricians regularly serve Pflugerville neighborhoods. Outdoor lighting work here involves the same Texas licensing rules that apply statewide, including the power-source requirement for landscape lighting.
Can a landscaper run landscape lighting wiring in Pflugerville?
Texas law lets landscapers install and maintain low-voltage exterior lighting and holiday lighting, but the exemption excludes the required power source. Anyone who performs electrical work in Texas must be licensed. So the transformer or connection tying into your home's electrical system needs a licensed electrician.
How long does landscape lighting wiring take to install?
Installing the wiring and a single outdoor light takes an electrician about 3 to 5 hours. A 10-fixture project is often estimated at 4 to 8 hours of labor, while first-time installers may need 8 to 12 hours. Experienced installers work closer to 0.4 hours per fixture versus about 0.7 for newer crews.
What does a full landscape lighting project cost in Pflugerville?
A complete low-voltage LED path-lighting system with 6 to 10 fixtures, a transformer, and cable runs about $500 to $1,200 professionally installed. A full design and installation with 20 to 30+ fixtures costs about $2,500 to $8,000. Typical residential projects average around $3,500.
What license should the electrician hold?
Texas licenses electricians through the state licensing system, with categories including contractor, master electrician, journeyman electrician, and residential appliance installer. Hiring should be based on the exact license class needed for the job. Ask the pro for proof of license and insurance before work starts.
What to do next
- Decide how many fixtures you want - 6 to 10 path lights runs about $500-$1,200, while 20 to 30+ fixtures runs $2,500-$8,000.
- Ask each pro for proof of a Texas electrician license, since the power-source connection must be done by someone licensed.
- Get the transformer tie-in to your home's electrical system included in the quote, not just the fixture wiring.
- Ask for an hourly estimate - a 10-fixture job typically takes 4 to 8 hours for an experienced installer.
- Call (737) 367-2100 or email [email protected] for a free quote from a licensed, insured electrician.
Austin Volts is a free referral service: an independent contractor does the work and may pay us a referral fee. You never pay us anything.
