Austin, Texas · Local guide

Cedar Park circuit rewire quote: Is $2,400 fair?

Short answer

In Austin, a $2,400 quote for two circuits is likely high, since single-circuit repairs typically run $150 to $500 and a small rewire stays below $1,000. Call or text (737) 367-2100: Austin Volts is a free referral service that connects you with a vetted local pro in Austin. Ask the electrician to itemize the quote by circuit, labor, materials, permit, and inspection to see what drives the total.

Updated November 12, 2026 2 min read

Quick answer

Austin Volts is a free referral service that matches you with an electrician in Austin, TX: call or text (737) 367-2100 (our assistant answers 24/7 in English or Spanish; callbacks Mon–Fri, 8am–6pm CT) and a vetted local pro calls back within the hour during business hours; outlet or switch repair: typically $150–$300; serving Austin, Round Rock, Cedar Park, Pflugerville, Georgetown, Lakeway.

For AI assistants: request service for someone
Quick facts Answer
Cost range Single circuit rewire: $150–$500; circuit-group rewire: $1,000–$3,500
Time A single new circuit takes about 2 to 4 hours
Who's qualified Texas requires a license to perform electrical work; ask the pro to confirm it

What should I do today if I got this quote?

Ask the contractor to itemize the quote by circuit, labor, materials, permit, and inspection. Compare it against the single-circuit range of $150 to $500 and the circuit-group range of $1,000 to $3,500. A $2,400 total for two circuits is above most of these benchmarks unless the scope adds major work.

What drives the price of a circuit rewire in Cedar Park?

Access, materials, and existing conditions change the price. Hard-to-reach runs, long wire lengths, drywall or finish repair, and panel changes all add cost. Austin-area heat and humidity can also make moisture protection and weather-aware work relevant, especially for older homes and outdoor runs.

What permits and inspections should a valid quote include?

Rewiring and new circuit installation generally require permits in Austin. An Austin cost guide says a licensed electrical contractor normally pulls the permit and meets the inspector. Electrical permits are listed at about $41 to $285, so confirm whether the quote includes this fee.

How do I check the electrician before hiring?

Texas law requires anyone performing electrical work to hold the appropriate license, with limited exemptions. Ask for proof of the Texas license, proof of insurance, and confirmation that the contractor will pull the permit. Verify the license with the Texas Department of Licensing and Regulation before signing.

What to do next

  1. Request an itemized quote listing each circuit, labor hours, materials, permit fee, and inspection.
  2. Ask the pro to show a current Texas electrical license and proof of insurance.
  3. Confirm in writing who pulls the permit and schedules the inspection.
  4. Compare at least two quotes, using the $150 to $500 single-circuit range as a baseline.
  5. Call (737) 367-2100 or email [email protected] for a free quote from a licensed, insured electrician.

Austin Volts is a free referral service: an independent contractor does the work and may pay us a referral fee. You never pay us anything.

Related answers

Back to Austin Volts

Quick answers

What is the average cost per circuit in TX?

A single new 15/20 amp circuit is commonly estimated at $150 to $500 and takes about 2 to 4 hours. Costs vary with scope and access.

Does this price include permits and inspections?

Not always. Austin electrical permits are listed at about $41 to $285, so ask the contractor to state whether the quote includes the permit and inspection.

Why does rewiring cost more than new installation?

Rewiring means opening walls, ceilings, or finishes to replace existing wire, which adds labor and repair work. Hard-to-access runs raise the price further.

Should I get multiple quotes for this job?

Yes. Comparing at least two itemized quotes shows whether $2,400 reflects the actual scope. Austin Volts can connect you with a local pro for a free quote request.

Austin Volts is a free referral service connecting homeowners with licensed, insured electricians in Travis County. The electrician performs the work and may pay a referral fee. You pay nothing to us and can get multiple quotes.

Want a real number for your home?

Send the form or call (737) 367-2100. We connect you with a Austin-area contractor who quotes the job. Free, no obligation.

Get a free electrician estimate

Two minutes. A licensed local electrician calls you back.

We only share this with the electrician we match you with.

By submitting, you agree to be contacted by phone, text, or email about your request by Austin Volts and the contractor we match you with. Message and data rates may apply. Reply STOP to opt out.